Ko temiihini momo pupuhi pupuhi miihini pupuhite tikanga he ahua rahi ake, a ko te mea whakauru he uaua ake i nga taputapu iti. Ko te whakauru tika me te miihini whakamatautau te mea nui ki te whakarite i te mahinga noa o nga taputapu o muri mai. Mena ko nga mahi tuatahi kaore i te tohunga, me kaha nga kaiwhakamahi ki te whai i nga tohutohu a nga kaimahi whai mana, ki te toro atu ranei ki nga tohutohu. Ma te kore e mana te whakahaere kaore e taea te whakahoki i temiihini pupuhi pupuhi pupuhi. Ko teshot blasting machine manufacturer has sorted out the precautions for installation and test machine to share with you. I hope it will be helpful to users who use the device for the first time.
1. Installation. Ko temiihini momo pupuhi pupuhi miihini pupuhi is installed and debugged in the production plant and disassembled into several parts before being transported to the user site for installation. Although there is no pit, the foundation must be firm, the anchor bolt holes must be standardized, and the chamber body must be adjusted. After the second irrigation, the anchor bolt nuts can be tightened after solidification. After the chamber body is fixed, the various parts can be installed. Ko teprecautions for the installation and debugging of the relevant components are introduced below.
1. Kopere pere taputapu:
Ko teshot blasting device has been installed on the chamber body before leaving the factory. Please pay attention to the problems to be debugged before use. Check whether the fixed positions of the blade, the pill wheel, the directional sleeve, and the guard plate are accurate and firm, and check whether the direction of rotation is correct after power on. Then adjust the position of the directional sleeve opening. Theoretically, the angle between the front edge of the directional opening and the front edge of the blade throwing position is about 900. After fixing the position of the directional sleeve, the position of the projectile belt can be detected by hanging Place a steel plate or wooden board on the position of the workpiece facing the exit of the shot blasting machine, start the shot blasting machine, put a small amount (2-5kg) of projectiles into the blasting tube, and then stop, check whether the hit position on the steel plate is suitable for the needs, such as Close the window of the bias-adjustable directional sleeve downwards, and vice versa, until it fits, and note the position of the directional sleeve opening as a basis for future replacement of the directional sleeve.
2. Hanga me te kaikawe nekeneke:
Tuatahi te whakahaere i te whakamatautau kore-kawenga hei tirotiro mena kei te rere te peere o te huti me nga matatini taraiwa i te huarahi tika, katahi ka whakakakahu i te whitiki o te huti ki te ahua ahotea ki te karo i te kotiti, katahi ka whakahaere i te whakamatautau kawenga hei tirotiro. te mahinga me te kawe i te kaha, ahakoa he rereketanga Noise me te wiri, tirohia me te tango i nga aukati.
3. Te whakawehe onepu-kirikiri:
Tuatahi tirohia mena he ngawari te nekehanga o te hipi toa, katahi ka tirotirohia te waahi tika o te pereti wehe, ka oti ana te hika ka utaina, ka rere tonu nga pupuhi maitai, ka tirohia mena e rere ana nga pupuhi maitai ka hinga ka oti te chute